McIntosh MA5200 Owner's Manual Page 30

  • Download
  • Add to my manuals
  • Print
  • Page
    / 32
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 29
30
Amplifier Specifications
Power Output
100 watts is the minimum sine wave continuous aver-
age power output per channel, both channels operating
Output Load Impedance
8 ohms
Rated Power Band
20Hz to 20,000Hz
Total Harmonic Distortion
0.005% maximum with both channels operating from
250 milliwatts to rated power, 20Hz to 20,000Hz
Dynamic Headroom
1.8dB
Frequency Response
+0, -0.5dB from 20Hz to 20,000Hz
+0, -3dB from 10Hz to 100,000Hz
Preamplifier Output (for rated input)
1V (8V Maximun)
Sensitivity (for rated output)
High Level, 250mV unbalanced, 500mV balanced
Phono MM, 2.5mV
Power Amp In, 1V
Signal To Noise Ratio (A-Weighted)
High Level, 95dB below rated output
Phono MM, 82dB below 5mV input
Power Amplifier, 110dB below rated output
Digital Input Sample Rates
Optical: 16Bit, 24Bit - 32kHz to 96kHz
Coaxial: 16Bit, 24Bit - 32kHz to 96kHz
USB: 16Bit, 24Bit, 32Bit - 32kHz to 192kHz
Power Control Output
12VDC, 25mA
Intermodulation Distortion
0.005% maximum, if the instantaneous peak power is
200 watts or less per channel with both channels oper-
ating for any combination of frequencies from 20Hz to
20,000Hz
Wide Band Damping Factor
Greater than 200
Input Impedance
High Level, 20K ohms
Phono MM, 47K ohms; 50pF
Power Amp In, 10K ohms
Maximum Input Signal
High Level, 8V unbalanced, 16V balanced
Phono MM, 80mV
Power Amplifier In, 8V
Preamplifier Output Impedance
220 ohms
Headphone Impedance
20 to 600 ohms
Power Guard
Less than 2% THD with up to 16dB overdrive at
1,000Hz
Voltage Gain
High Level to Preamp: 12dB
Phono MM to Preamp: 52dB
Power Amplifier: 29dB
Amplifier Specifications
General Specifications
Power Requirements
Field AC Voltage conversion of the MA5200 is not
possible. The MA5200 is factory configured for one
of the following AC Voltages:
100 Volts, 50/60Hz at 2.7 amps
110 Volts, 50/60Hz at 2.3 amps
120 Volts, 50/60Hz at 2.3 amps
220 Volts, 50/60Hz at 1.3 amps
230 Volts, 50/60Hz at 1.2 amps
240 Volts, 50/60Hz at 1.2 amps
Standby: Less than 0.25 watt
Note: Refer to the rear panel of the MA5200 for the cor-
rect voltage.
Overall Dimensions
Width is 17-1/2 inches (44.5cm)
Height is 6 inches (15.2cm) including feet
Depth is 22 inches (55.9cm) including the Front Panel,
Knobs and Cables
Weight
38 pounds (17.2 kg) net, 55.5 pounds (25.2 kg) in ship-
ping carton
Shipping Carton Dimensions
Width is 26-1/2 inches (67.3cm)
Depth is 24-1/4 inches (62.2cm)
Height is 11-3/4 inches (29.9cm)
Page view 29
1 2 ... 25 26 27 28 29 30 31 32

Comments to this Manuals

No comments