McIntosh MA5200 Owner's Manual download pdf (Page 21)

The MA5200 incorporates an Auto Off Feature, which

automatically places the preamplifier into the Power

Saving Standby/Off Mode. This occurs approximately

30 minutes after there has been an absence of audible

audio signals on the selected input (on either chan-

nel) or user activity (includes changes to any of the

Operation Functions such as source selection, volume

adjustment, etc). If it is desirable to disable the Auto

Off Feature perform the following steps:

1. Press and hold the INPUT CONTROL until the

Front Panel Display indicates the Setup Mode is

active. Then rotate the INPUT CONTROL until

the Setup Menu item “SETUP: POWER MODE,

Auto Off: Enabled” appears on the Front Panel

Display. Refer to figure 19.

2. Rotate the VOLUME Control until “SETUP:

POWER MODE, Auto Off: Disabled” appears on

the Front Panel Display. Refer to figure 20.

3. To exit from the Setup Mode, press the INPUT

CONTROL and the Front Panel Display will revert

back to its normal display.

Note: To reset the Remote Control to normal

codes perform steps A and B then enter

3, 2, 4, 2 and 8 for step C.

5. Press the VOLUME UP/DOWN Push-button on

the Remote Control to verify proper operation.

Power Mode

Figure 19

SETUP: POWER MODE

Auto Off: Enabled

Figure 20

SETUP: POWER MODE

Auto Off: Disabled

Setup, con’t

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 31 32

No comments

McIntosh MA5200 Owner's Manual Page 21