McIntosh MCD1100 Owner's Manual download pdf (Page 18)

into memory. Refer to figure 22.

Note: The Front Panel Alphanumeric Display will

momentarily indicate three dashes under the word

“TRACK”. Then display will indicate the track

number, the First Program Step Number “ 1 ” is

now on continuously and a flashing Second

Program Step Number “ 2 ” will appear.

4. Additional Track Selections may be entered into

memory at this time by repeating the process outlined in

step three. The Front Panel Alphanumeric Display indi-

cates that Program Steps “ 1 ” and “ 2 ” are on continu-

ously and the next available Program Step will be flash-

ing. Refer to figure 23.

5. To start playback of the just entered into memory Pro-

gram Selections, press the PLAYPushbutton. Refer to

figure 24.

Deleting a Program

The MCD1000 will keep an entered Program in its nonvola-

tile memory for Playback, even if AC Power is removed. To

delete the Program stored in memory press the Front Panel

OPEN/CLOSE Push-button.

Modify a Program

Sometimes after a Playback Program has been created, it

might be desirable to make changes to the existing Program

instead of deleting it and starting all over again.

How to Operate the MCD1000 con’t

Figure 23

Figure 24

Note: Changes to a program include the changing of any

tracks currently entered into memory and adding new

program steps to the end.

1. Press the PGM (Program) Push-button on the Remote

Control to activate the Programing Mode on the

MCD1000.

2. Press the PAUSE Push-button and the first track of

the stored program will start playing.

3. To change the first progam track use either the

NEXT and BACK Push-buttons or the NUM-

BER (0 thru 9) Push-buttons to select the new track and

then press the PGM Push-button to enter it into the cur-

rent memory location.

Note: If the first program track selection doesn’t need to

be changed, just press the PGM Push-button and

the second Program Step Location will become

available for changing. Continue to press the PGM

Push-button until the track to be changed is audible

and perform step 3 to enter the new selection.

4. Add any new program steps by repeating step 3.

5. To start playback of the Program Selections just entered

into memory, press the PLAYPushbutton.

Resetting of Microprocessors

In the event that the controls of the MCD1000 stop func-

tioning, place the POWER Switch in the OFF position for 5

seconds, then back ON. This will reset the MCD1000 Mi-

croprocessors.





Figure 22

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 24

Comments to this Manuals

No comments

McIntosh MCD1100 Owner's Manual Page 18

Comments to this Manuals