McIntosh MCD1100 Owner's Manual download pdf (Page 14)

How to Operate the MCD1000

Press the POWER switch to ON, the Red LED above the

STANDBY/ON Push-button lights to indicate the

MCD1000 is in Standby Mode. To Switch On the

MCD1000 press the STANDBY/ON Push-button. With no

CD Disc loaded in the CD Transport the Front Panel Alpha-

numeric Display will indicate “Track 0” Refer to figures 1

and 8.

Notes: For normal operation, switch the MCD1000 On and

Off with the Standby/On Push-button. If the Disc

Player is not going to be used for an extended period

of time, turn Off all AC Power with the Power

Switch. When the MCD1000 Power Control Jack is

connected (via a cable) to a McIntosh MDA1000 D/A

Converter, Control Center, A/V Multizone System

Controller or Preamplifier, the MCD1000 will

automatically switch ON and OFF with the system.

When power is first applied, the MCD1000 will

determine if a disc is present inside and during that

time the OPEN/CLOSE Push-button is not active

until a triangle appears on the Alphanumeric

Display.

Loading a Compact Disc

Before inserting a disc into the MCD1000 CD Transport

please read Important Information notes Numbers 8, 9, 10

and 11 found on page 5.

Notes: If an attempt to play disks other than those specified in

the Important Information notes number 8 occurs, the

MCD1000’s normal operation may stop. If this were to

happen, first place the Front Panel POWER Switch to

Off. Then press and hold the OPEN/CLOSE Push-

button followed by placing the POWER Switch to the

On position. Release the OPEN/CLOSE Push-button

when the alpha numeric displays “Track 0”. The Disc

Tray will open (in about 10 seconds) and the non-

playable disc may be removed. Follow the above

procedure if a defective CD Disc refuses to playback

properly.

1. Press the Front Panel OPEN/CLOSE Push-button and

the Disc Loading Tray will slide open to permit the in-

sertion of a Disc into the MCD1000. Refer to figures 2

and 8.

2. Insert the disc into the Disc Tray and press the Front

Panel OPEN/CLOSE Push-button and the Disc Load-

ing Tray will draw the Disc into the Transport. Refer to

figure 3.

Figure 1

Figure 5

Figure 3

Disc

seated in

the tray

Give the

tray a

nudge

Figure 4

Notes: For immediate playback of the Disc press the

PLAY Push-button instead of OPEN/CLOSE Push-

button. The Disc Tray will also close by giving the

front edge of the tray a nudge, refer to figure 4.

3. The Front Panel Alphanumeric Display will indicate the

number of Tracks and the Total playing time. Refer to

figure 5.

Figure 2

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 23 24

Comments to this Manuals

No comments

McIntosh MCD1100 Owner's Manual Page 14

Comments to this Manuals