McIntosh MX 110 Specifications download pdf (Page 8)

HOW TO INSTALL YOUR

Ml 3 IN A CABINET

1 Use the mounting template to position where you will mount the

instrument.

NOTE: The template lets you position the cutout from the front of

the panel.

2 Mark the "A" and "B" drill holes.

3 Mark the four corners. Join the four corners to make a rectangle.

Use the edge of the template as a straight edge.

4 Drill the mounting holes and cut out the rectangular hole.

5 Fasten the two mounting strips to the panel. Use two of the fillister-

head screws provided. There are 12 fillister-head screws in the

package. Six are % inches long and six are 1 % inches long. For

panels under ½ inch thick use the ¾ inch screws. For panels over

½ inch thick use the 1¼ inch screws. Insert a screw in the center

hole. ("B" hole on the template.) Tighten the screws so the heads

are pulled half of their thickness into the wood.

6 Fasten the shelves to the mounting brackets. Use two fillister-head

screws in the "A" holes for each shelf.

7 Place the template over the mounting screws. The screws should

be centered in the "A" and "B" holes on the template. The PAN-

LOC shelves should match the vertical dash lines on the template.

8 Remove the plastic protective covering from the instrument. Turn

the instrument over. To prevent damage rest the instrument on

the shipping pallet.

9 Remove the four (4) plastic feet.

10 Now the instrument is ready for installation.

11 Put the power cord through the opening. Slide the unit into the

brackets. Carefully slide the Ml 3 into the opening so the plastic

rails on the bottom of the chassis engage the grooves in the metal

mounting brackets. Slide the Ml 3 in until its front panel is against

the cabinet mounting panel.

12 Secure the instrument to the mounting bracket by pushing "in" the

Panloc Buttons.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

No comments

McIntosh MX 110 Specifications Page 8