McIntosh MC2102 Owner's Manual Page 18

  • Download
  • Add to my manuals
  • Print
  • Page
    / 20
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 17
18
Specifications
Specifications
Power Output Stereo
Minimum sine wave continuous average power output per
channel, all channels operating is:
100 watts into 2 ohm load
100 watts into 4 ohm load
100 watts into 8 ohm load
Power Output Mono Parallel
Minimum sine wave continuous average power output is:
200 watts into 1 ohm, 2 ohm or 4 ohm load
Power Output Mono Bridge
Minimum sine wave continuous average power output is:
200 watts into 4 ohm, 8 ohm or 16 ohm load
Rated Power Band
20Hz to 20,000Hz
Total Harmonic Distortion
Maximum Total Harmonic Distortion at any power
level from 250 milliwatts to rated power output is:
0.5% for 2, 4 or 8 ohm loads (Stereo)
0.5% for 1, 2 or 4 ohm loads (Mono Parallel)
0.5% for 4, 8 or 16 ohm loads (Mono Bridge)
Frequency Response
+0, -0.25dB from 20Hz to 20,000Hz
+0, -3dB from 10Hz to 70,000Hz
Sensitivity
2.5Volt unbalanced inputs
5.0Volt balanced inputs
A-Weighted Signal To Noise Ratio
100dB
Intermodulation Distortion
Maximum Intermodulation Distortion if instanta-
neous peak output does not exceed twice the rated
output, for any combination of frequencies from
20Hz to 20,000Hz is:
0.5% for 2, 4 or 8 ohm loads (Stereo)
0.5% for 1, 2 or 4 ohm loads (Mono Parallel)
0.5% for 4, 8 or 16 ohm loads (Mono Bridge)
Input Impedance
20,000 ohms unbalanced inputs
40,000 ohms balanced inputs
Wide Band Damping Factor
Greater than 18
Power Requirements
100 Volts, 50/60Hz at 6.0 amps
110 Volts, 50/60Hz at 5.5 amps
120 Volts, 50/60Hz at 5.0 amps
220 Volts, 50/60Hz at 2.5 amps
230 Volts, 50/60Hz at 2.5 amps
240 Volts, 50/60Hz at 2.5 amps
Note: Refer to the rear panel of the MC2102 for the correct
voltage.
Tube Compliment
4 - 12AX7A Inputs and Phase Inverters
4 - 12AT7 Voltage Amplifier and Drivers
8 - KT88/6550 Power Output
Dimensions
Front Panel: 17-3/4 inches (45.54cm) wide, 10-1/8 inches
(25.72cm) high. Depth behind front mounting panel is 16
inches (40.64cm). Clearance required in front of the Front
Panel is 1 inch (2.54cm) for knobs.
Weight
88 pounds (40 kg) net, 121 pounds (54.9 kg) in shipping
carton
Page view 17
1 2 ... 13 14 15 16 17 18 19 20

Comments to this Manuals

No comments