McIntosh MC-7108 User Manual download pdf (Page 10)

REAR PANEL

AND HOW

TO MAKE

CONNECTIONS

CONTROL IN connector from the POWER CONTROL OUT connector on compatible Mcln-

tosh products. The MC7108 POWER CONTROL OUT jack will feed the same AC power con-

trol signal out, delayed 0.2 seconds, to turn on and off another accessory component with

a compatible Power Control input.

The MC7108 POWER switch must be in the OFF/REMOTE setting for the power control

signals to turn the MC7108 On and Off.

The POWER CONTROL connectors are standard 1/8 inch mini phone plugs. Only the tip

and sleeve are used for connecting the plug to a single conductor shielded cable.

10. CHANNELS 3 and 4, IN - OUT

BRIDGED: Connect a cable from a Preamplifier or Control Center to 3 IN.

STEREO: Connect cables from the stereo outputs of a Preamplifier, Control Center or other

accessory component to 3 IN and 4 IN.

MONO: Connect cables from the stereo outputs of a Preamplifier or Control Center to 3

IN and 4 IN. The stereo signals will be combined to Mono and fed to each amplifier channel.

The two LEVEL controls will work separately on each channel.

The OUT jacks provide a convenient connection to feed the same signals to other chan-

nels on the MC7108, or to any accessory component.

11. LEVEL (BRIDGED, STEREO and MONO)

BRIDGED: Use only the 3 BRIDGED LEVEL control and adjust as desired.

STEREO: Adjust the individual 3 and 4 LEVEL controls as desired. The 2.5V setting is sug-

gested when the MC7108 is being used with a Mclntosh Preamplifier or Control Center.

MONO: Adjust the individual 3 and 4 LEVEL controls as desired. The combined 3 and 4

Mono signals will be reproduced by each channel.

12. MODE (BRIDGED, STEREO and MONO)

Set the MODE switch to the position for the desired operating configuration.

13. CHANNELS 1 and 2, IN - OUT

BRIDGED: Connect a cable from a Preamplifier or Control Center to 1 IN.

STEREO: Connect cables from the stereo outputs of a Preamplifier, Control Center or other

accessory component to 1 IN and 2 IN.

MONO: Connect cables from the stereo outputs of a Preamplifier or Control Center to 1

IN and 2 IN. The stereo signals will be combined to Mono and fed to each amplifier channel.

The two LEVEL controls will work separately on each channel.

The OUT jacks provide a convenient connection to feed the same signals to other chan-

nels on the MC7108, or to any accessory component,

14. LEVEL (BRIDGED, STEREO and MONO)

BRIDGED: Use only the 1 BRIDGED LEVEL control and adjust as desired.

STEREO: Adjust the individual 1 and 2 LEVEL controls as desired. The 2.5V setting is sug-

gested when the MC7108 is being used with a Mclntosh Preamplifier or Control Center.

MONO: Adjust the individual 1 and 2 LEVEL controls as desired. The combined 1 and 2

Mono signals will be reproduced by each channel.

15. MODE (BRIDGED, STEREO and MONO)

Set the MODE switch to the position for the desired operating configuration.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 25 26

Comments to this Manuals

No comments

McIntosh MC-7108 User Manual Page 10

Comments to this Manuals

Related products and manuals for Musical Equipment McIntosh MC-7108