McIntosh Laboratory, Inc. 2 Chambers Street Binghamton, New York 13903-2699 Phone: 607-723-3512 www.mcintoshlabs.comXCS200Loudspeaker SystemO

10Room Acoustics and LoudspeakerPlacementfront of the Loudspeaker of at least 30 degrees either side from the center axis for the best performance. Re

112. Connect a Loudspeaker cable from the XCS200 LOW Frequency COM Binding Post to the CTR (Center) Channel COM (-) Binding Post of the Multichannel P

12How to Connect using Two Amplifiers2. Remove the metal jumper between the Loudspeak-er LOW Frequency COM (-) Binding Post and MID Frequency COM (-)

13How to Connect using Two AmplifiersJumperJumperPower Amplifier number TwoPower Amplifier number One

14How to Connect using Three Amplifiers2. Remove all four metal jumpers between Loud-speaker Binding Posts.3. Connect a Loudspeaker cable from the XCS

15How to Connect using Three AmplifiersPower Amplifier number ThreePower Amplifier number Two

16

17Photos

18SpecificationsSpecifications General SpecificationsSystem Driver ComplementTwo 8 inch LD/HP® WoofersEight 2 inch Titanium InvertedDome MidrangesFive

19Packing InstructionsPacking InstructionsIn the event it is necessary to repack the equipment for shipment, the equipment must be packed exactly as i

2WARNING - TO REDUCE RISK OF FIRE OR ELECTRICAL SHOCK, DO NOT EXPOSE THIS EQUIPMENT TO RAIN OR MOISTURE.NO USER-SERVICEABLE PARTS INSIDE. RE-FER SERVI

The continuous improvement of its products is the policy of McIntosh Laboratory Incorporated who reserve the right to improve design without notice.Pr

31. For additional connection information, refer to the owner’s manual(s) for any component(s) connected to the XCS200 Loudspeaker.2. The XCS200’s bui

4IntroductionMcIntosh Acoustic Engineers have achieved in the design of the XCS200 Loudspeaker System a level of high performance. The XCS200 provides

5Introduction and Performance Features Performance Features• Patented LD/HP® TechnologyThe McIntosh Low Frequency Loudspeaker Elements feature the pat

6DimensionsThe following dimensions can assist in determining the best location for your XCS200.End View of the XCS20032-1/2"82.55cm10-5/8"

75. Tighten the three screws securing the Stabilizer Bar to keep it in place, but not enough to prevent changing the angle of the XCS200 in the follow

84. Determine the Loudspeaker Mounting Location on the wall, making sure the Mounting Bracket will be anchored to a stud located inside the wall.Note:

9Installing the XCS200 on the WallFigure 9Figure 8Figure 10Figure 11 7”17.8cm 16”40.6cm 6-1/4” 15.9cmFigure 14 16”40.6cm 7-7/8 ”20.0cm 8-1/4” 2