McIntosh MCC204 Owner's Manual download pdf (Page 8)

How to Connect for Four Channels

1. Connect a wire from the Control Center Amp On to the

MCC204 ON Connector on the right side of the ampli-

fier.

Note: All cables should be connected to the amplifier

before connecting the DC power cables to the

battery.

2. Connect a wire from a McIntosh Control Center with

Power Guard to the MCC204 PG Connector on the

right side of the amplifier.

3. Connect cables (up to 12AWG) from four separate

loudspeakers, to the Amplifiers Channels 1, 2, 3 and 4

OUTPUT Terminals, being careful to observe the cor-

rect polarities.

4. Connect audio cables from the Control Center Outputs

to the MCC204 Inputs 1, 2, 3 and 4.

5. Optional Connection illustrated below shows the SUB

OUTput connected to a separate Subwoofer Power

Amplifier and Subwoofer Loudspeaker.

Note: The Subwoofer Output Signal is at line-level,

summed from all the Input Channels and is

available regardless of the MCC204 Operating

Mode used. The Subwoofer Output Level can be

remotely controlled by the optional McIntosh

External Subwoofer Rotary Control connected to

the SUB REMOTE CONTROL jack on the

MCC204.

6. Connect the MCC204 to the vehicle battery terminals

using size 4AWG (maximum) cables.

Note: It is advisable to place an inline fuse of a suitable

size as close as possible to the battery.

Right Rear

Left Rear

Left Front

Right Front

Subwoofer

Loudspeaker

Optional Subwoofer Amplifier

Vehicle

Battery

Fuse

McIntosh Control Center

Power Guard

Amp ON

Left Front

Loudspeakers

Right Front

Loudspeakers

Right Rear

Loudspeakers

Left Rear

Loudspeakers

McIntosh External

Subwoofer Rotary Control

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 19 20

Comments to this Manuals

No comments

McIntosh MCC204 Owner's Manual Page 8

Comments to this Manuals

Related products and manuals for Car audio amplifiers McIntosh MCC204