McIntosh MR85 Owner's Manual download pdf (Page 14)

The MR85 AM/FM Tuner allows for presetting your favor-

ite radio stations into memory. It will also remember any

desired audio modes of operation such as Stereo/Mono and

Spatial Enhancement for each station separately. To enter

Presets and Audio Modes follow the below steps:

Note: The MR85 Tuner 1 and the optional secondary Tuner 2

Module each can store up to 9 AM and 9 FM stations.

1. Select the AM or FM broadcast band.

2. Tune to the desired radio station with either the Front

Panel TUNING Knob or the SEEK p (Up) and q

(Down) Push-button(s).

3. Optionally, select the Mono and/or Spatial Enhance-

ment Modes of Operation for that station.

Note: The Spatial Enhancement Mode is only applicable to

the Tuner 1. All AM Radio Stations are automatically

received in Mono.

4. Momentarily press and release the Front Panel ENTER

push-button. The LED above the ENTER push-button

will light and the Front Panel Display will indicate 1

AVAILABLE, which is the first of 9 Preset Numbers

that can be assigned. Refer to figure 4.

Note: Presets are automatically assigned in order from 1 to 9.

5. Press and release the front panel ENTER push-button a

second time to store the Preset into memory, the LED

above the ENTER push-button will turn off and that

station Preset Selection will be assigned Preset Num-

ber 1. The assigned Preset Number will appear on the

Front Panel Display to the right of the Station Fre-

quency whenever it is selected. Refer to figure 5.

6. Assign additional station Presets by performing steps 1

How to Assign Preset Stations

How To Clear an Assigned Station Preset

1. Press and release the ENTER Push-button; the LED

above the ENTER Push-button will light.

2. Rotate the PRESET Knob clockwise or counterclock-

wise to select the desired Station Preset you wish to

clear.

3. Press and Hold the ENTER Push-button for approxi-

mately 3 seconds until the Front Panel Display indi-

cates the word CLEARED. Refer to figure 6.

Note: If you wish to replace an already assigned Station

Preset with another radio station, it is not necessary to

clear the Preset first, just enter in the new station for

that Preset. The new station will automatically replace

the previously assigned station.

4. To clear any additional Station Presets perform steps 1

through 3 again.

Figure 6

Figure 5

through 5 until a total of 9 AM and 9 FM Station Pre-

sets have been assigned. Each time you assign an addi-

tional Preset Number, the Front Panel Display will in-

dicate the number of the next available preset.

Note: If all 9 presets are assigned and you press ENTER, the

display will indicate the station selected for preset

number 1.

7. To verify the Station Preset(s) you have just entered ro-

tate the PRESET Knob clockwise or counterclockwise

to cycle through and confirm your preset assignments.

STANDBY/ON Push-button, lights to indicate the MR85 is

in Standby Mode. To turn ON the MR85, press the

STANDBY/ON Push-button.

Note: The above condition is usually caused by either

interruptions or changes in AC voltage.

Figure 4

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 20

Comments to this Manuals

No comments

McIntosh MR85 Owner's Manual Page 14

Comments to this Manuals