McIntosh C33 Specifications download pdf (Page 18)

ed such as rear channel reverberation units, color

displays, etc. For example Output 1 or 2 can be con-

nected to a reverberation device and then to the C 33

monitor amplifier and a set of rear loudspeakers.

(The monitor amplifier switch must be in the EXTER-

NAL position.) Rear channel reverberation can then

be switched in and out without the need for an extra

amplifier.

SPEAKER 1 AND 2 USING THE SCR

When pushbutton 1 is in and pushbutton 2 is out,

the MAIN speakers will be connected to the power

amplifier via the relays in the SCR. The red light

above 1 will be on. When pushbutton 1 is out and

pushbutton 2 is in, the remote speakers will be con-

nected instead. The red light above 2 will be on.

When both pushbuttons 1 and 2 are in, both sets of

speakers will be connected and lights 1 and 2 will be

on. CAUTION: When both sets of speakers are con-

nected at the same time, their combined parallel im-

pedance must not be too low for the power amplifier

to handle. For example: If both sets of speakers are

8 ohms, connections to the power amplifier must be

to the 4 ohm tap. If the amplifier does not have dif-

ferent impedance taps, it must be able to deliver

power to a 4 ohm load as well as an 8 ohm load.

POWER ON

The red pushbutton turns the C 33 on and off.

When the power is on, the panel illuminates and the

red light above this pushbutton will go on. The turn-

table can also be used as a power switch. See page 8.

-16-

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 27 28

No comments

McIntosh C33 Specifications Page 18