McIntosh Laboratory, Inc. 2 Chambers Street Binghamton, New York 13903-2699 Phone: 607-723-3512 FAX: 607-724-0549MT10Owner’s ManualPrecision
10Assembling the Turntable, con’t19. Locate the Mc-Intosh Bubble Level and place it on the Turntable Plat-ter Mat. If the Bubble is not in the center
11Rear Panel Connections and AdjustmentsPOWER CONTROL REMOTE IN receives turn-on signals from a McIntosh component and switches the Front Panel Illumi
12How to Connect the TurntableHow to Connect the TurntableMcIntosh Preamplifier1. Connect a Power Control Cable from the MT10 POW-ER CONTROL REMOTE IN
13Front Panel Display, Switches, Lever and Record ClampMeter indicates actual rotation speed of the turntable platterPOWER Switch turns AC Power On/Of
142. Release the Tone Arm from the Tone Arm Holder. Refer to figure 54.3. Position the Tone Arm over the desired spot of the Pho-tograph record.4. Pul
15Notes
17Notes
18General SpecificationsMT10 Turntable SpecificationsOverall DimensionsWidth is 17-1/2 inches (44.45cm)Height is 8-13/16 inches (22.38cm)Depth is 21 inc
19Packing InstructionsPacking InstructionsIn the event it is necessary to repack the equipment for shipment, the equipment must be packed exactly as s
2The lightning flash with arrowhead, within an equilateral triangle, is intended to alert the user to the presence of uninsulated “danger-ous voltage”
The continuous improvement of its products is the policy of McIntosh Laboratory Incorporated who reserve the right to improve design without notice.Pr
3Thank YouYour decision to own this McIntosh MT10 Precision Turn-table and MCC10 Moving Coil Cartridge ranks you at the very top among discriminating
4General Information and Cable InformationGeneral InformationCaution: To prevent possible damage to the turntable platter bearing, do not move the MT1
5IntroductionPerformance FeaturesThe McIntosh MT10 Precision Turntable with the McIn-tosh MCC10 Moving Coil Cartridge offers the latest in playback of
6DimensionsDimensionsThe following dimensions can assist in determining the best location for your MT10.17-1/2"44.45cmFront View of the MT10Rear
7Unpacking the TurntableUnpacking the TurntableTo protect the fine finish of the MT10 Precision Turntable during the assembly and adjustment process,
84. Insert the two screws (from step 2) through the top of the headshell and into the Cartridge Body and fasten them with a small screwdriver. Make su
9Assembling the Turntableup with the Mc-Intosh MCC10 Car-tridge postion marking on the suface. Refer to figure 13. Then tighten the knurled knob to se
Comments to this Manuals