MC2301 Product Preview Page 1
MCINTOSH LABORATORY INC., 2 CHAMBERS STREET, BINGHAMTON, NEW YORK 13903
PRODUCT PREVIEW
MC2301
TUBE
POWER AMPLIFIER
Project 1336
McIntosh Laboratory, Inc., Binghamton, NY
13903
Design Engineering Department
Promotional Highlights
• 300 Watts Mono Power Output
• Balanced Design
• McIntosh Unity Coupled Output Circuit
• Multifilar Wound Output Transformers
• Low Distortion from 20Hz to 20kHz
• Wide Power Bandwidth
• Sentry Monitor Tube Protection
• Large Gold Plated Five-Way Binding
Posts
• Two Balanced Inputs/Outputs
• Large Illuminated Output Wattmeter
• Stainless Steel Chassis
• Fiber Optic Light Diffuser Illumination
• Remote Power Control with Meter light
control
• ½ Inch Thick Glass Front Panel With Tube
View
Features and Benefits
BALANCED DESIGN
The MC2301 amplifier is fully balanced
from input to speaker output. Two matched
amplifiers operate in Push-Pull with their
outputs combined in the Output Transformer.
The balanced configuration cancels many
distortion products. The Signal-to-Noise ratio
is also superior.
MCINTOSH UNITY COUPLED OUTPUT
CIRCUIT
Output power is taken from both the plate
and cathode of the output tubes. Conventional
designs only take output from the plate. This
allows ½ the turns ratio, or ¼ the impedance
transformation of conventional designs. The
result is much lower distortion, wider
bandwidth and increased loudspeaker
damping factor.
MULTIFILAR WOUND OUTPUT
TRANSFORMER
The Unity Coupled Output Transformer
has two bifilar wound primaries, one for the
cathodes and one for the plates. The
secondary is wound together with the primary
windings. This provides very close primary to
secondary coupling. The result is flat
frequency response and wide power
bandwidth.
LOW DISTORTION FROM 20Hz TO 20kHz
Less than 0.5% THD over the entire audio
band is uncommon for a tube amplifier.
WIDE POWER BANDWIDTH
Full power output is available well beyond
the frequencies that can be heard by humans.
The specified frequency range is 20 to
20,000Hz.
SENTRY MONITOR TUBE PROTECTION
Sentry Monitor protects the entire amplifier
circuitry in the event that a mismatched load
impedance or a failed Output Tube causes
higher than normal current to flow. To prevent
destruction, the MC2301 power is turned off.
LARGE GOLD PLATED FIVE-WAY BINDING
POSTS
McIntosh gold output terminals deliver full
Comments to this Manuals