McIntosh MA6500 Owner's Manual download pdf (Page 7)

How to Connect Loudspeakers

and Sensor Components

How to Connect Loudspeakers and Sensor

Components

1. Prepare the loudspeaker hookup cables as follows:

A. Carefully remove sufficient insulation from the

loudspeaker cable ends to just fit within the bind-

ing post with no

exposed wire acces-

sible. Refer to fig-

ure 1.

B. If the cable is

stranded, carefully

twist the strands

together as tightly

as possible. Refer

to figures 2 & 3.

Note: If desired, the

twisted cable

section can be

tinned with a

solder iron to

keep the

strands

together and/

or attach

appropriate

connector ends.

C. Insert the bare section of the cable end or connector

into the access hole, and tighten the terminal nut

clockwise until the cable is firmly clamped into the

terminal so the wires cannot slip out. Refer to fig-

ures 4, 5 & 6.

Note: The bare sections of the cable ends or the non

insulated part of the connectors must not be

exposed on either side of the terminal access

hole.

D. Repeats Steps A through C for each speaker cable

used with the amplifier.

4. Connect the loudspeaker cables to the appropriate ter-

minals for your loudspeakers, being

careful to observe the correct polari-

ties.

5. Install the plastic protective loud-

speaker terminal covers that were

supplied with your amplifier. Refer

to figure 7.

6. Optionally connect a Coax cable from the EXT SEN-

SOR to a McIntosh Wall Sensor or WK-2 Keypad in a

second room.

Right Loudspeaker

4 ohm

Figure 7

Left Loudspeaker

4 ohm

Right Loudspeaker

4 ohm

Left Loudspeaker

4 ohm

Second Room

McIntosh

IR Remote

Sensor

1 2 3 4 5 6 7 8 9 10 11 12 ... 19 20

Comments to this Manuals

No comments

McIntosh MA6500 Owner's Manual Page 7

Comments to this Manuals

Related products and manuals for Audio amplifiers McIntosh MA6500