McIntosh C26 User Manual download pdf (Page 5)

instrument in until the front panel is against the

cabinet panel. At the bottom front corners of the

PANLOC instruments are the PANLOC buttons.

Depressing the PANLOC buttons will lock the in-

strument firmly in the installation. Depressing the

PANLOC buttons a second time (as with a ball-

point pen) will release the instrument. You can

then slide the instrument forward to the inspec-

tion-adjustment position. Depressing the inspec-

tion-adjustment position latches will allow the in-

strument to be slid completely out of the installa-

tion.

Insert the screws in the center holes of the cabi-

net panel ("B" holes on the template) and tighten.

The screw head should pull into the wood slightly.

(Use two ¾ inch long screws for panels under ½

inch, or two 1¼ inch long screws for panels ½ inch

thick and larger.)

Attach the mounting brackets to the cabinet

using four screws.

Place the template over the mounting screws.

The mounting screws should be centered in the

"A" and "B" holes on the template. The sides of

the mounting brackets should match the vertical

dash lines on the template. If necessary, loosen

the screws and push the brackets into alignment

and retighten.

Insert the power cord through the opening.

Carefully slide the C 26 into the opening so the

rails on the bottom of the equipment slide in the

track of the mounting brackets. Slide the instru-

ment in until it stops at the adjust position latches.

Press the latches in and continue to slide the

1 2 3 4 5 6 7 8 9 10 ... 19 20

No comments

McIntosh C26 User Manual Page 5